Brass Moulding Insert

 Brass insert Brass Moulding Insert Brass Plastic Moulding Insert Brass Plastic Molding insert Brass Injection Moulding Insert Brass Injection Molding Insert Brass roto molding Roto moulding insert Brass insert for cold moulding Hot insert molding

Brass Moulding Insert Special Feature :

• Thread as per International Go & Not Go Standard

• . Brass Stainless Steel Nuts Moulding insert molding nut 

• Deep Groove for maximum Pull Out Resistance.

• Inner Diameter (I/D) after Thread with very close tolerance to prevent unnecessary flush to enter into the inserts.

• Knurling Available :

  • Diamond

  • Straight

  • Unidirectional

• Both blind and through inserts are available with no minimum Qty.

 Special Brass insert Moulding Insert Molding Brass insert Available

We shall be pleased to develop Non-Standard Brass insert component  nut screw stud fixing wood screw machine screw fastener as per specific requirement.

 Material   Brass to BS 2874 / 2872

 Finish   Brass natural, Electro-Tinned, Nickel etc.

 Thread    ISO Metric, BSW, BA, BSF, UNC, UNF UNEF etc.

Thread: 2mm 3mm 4mm 5mm 6mm 8mm 10mm 12mm 16mm 20mm 25mm 32mm 1/8" 5/32" 3/16" 1/4" 5/16" 3/8" 1/2" 5/8" 3/4" 1" 11/8" 11/4" 11/2" 13/4" 2"

BRASS STRAIGHT KNURLED MOULDING INSERT

Features: They are  one one thro' hole Brass  inserts. They can be potted in or moulded. A straight knurl offers better torque out capabilities.

Sizes: from  2mm -10mm

BRASS HELICAL MOULDING INSERT MOLDING NUT

Feature: They are compact inserts suitable for insertion in all type of plastic and can be used with hot plastic Moulding and cold plastic molding . Insert  are best suitable for electrical moulded box application..

Size: from  2mm -12mm and 1/8" - 1/2"

Brass Insert for CPVC and UPVC Drainage and Sewerage fitting Moulding

Feature: These Brass inserts are used for UPVC moulding CPVC molding for dewerage and daringae pipe fitting elbow and Pipe coupling .

Size: from  1/4"mm -3/4" mm

BRASS INSERT FOR WOOD AND PLASTIC

Feature: These Brass insert are push fit type and are used with Wood and plastic moulding. .

Size: from  1/4"mm -3/4" mm

BRASS SELF TAPPING INSERT

Feature: These insert are suitable for installation with wide range of thermoplastic and are sued where high pull out torque is required.

Size: from  1/4"mm -3/4" mm

BRASS KNURLED MOULDING SCREW

Feature: These screw are used for moulding of Nylon spacer and pillar.

Size: from  2mm-10mm and 1/8"-3/8"